Main Connection Settings; Aux Connection Settings - Wiznet WIZ630wi User Manual

5.1 Main Connection settings

Type
Status
Protocol
Mode
Server IP
Server Port
Reconnect Interval
Connection
Baud rate
Databits
Parity
Stopbits
FlowControl

5.2 Aux Connection Settings

Type
Status
Protocol
Mode
Server IP
Server Port
© Copyright 2012 WIZnet Co., Inc. All rights reserved.
Enable checked : Serial to LAN is used.
Enable un-check: Serial to LAN is not used.
Protocol used in Serial to LAN communication
-TCP
-UDP
Serial to LAN operation mode. ( Client Mode recommended)
- Server : waits for connection.
- Client : connected to the remote server of WIZ630wi
- Mixed : not recommended
Enter the IP address for WIZ630wi setting.
Enter the port number for remote serial data server host PC.
Interval of TCP reconnection.
WIZ630wi의 Serial LAN의 connection Type( TCP Only)
System Bootup : connected to the remote server upon bootup.
Serial Data In : once serial data comes in, connect to remote server.
(end connection after inactive time)
Select the serial communication speed.
Select the databits.
Select the method for parity check.
Select the stopbits.
Select the method for flow control. (Option: none, Xon/Xoff, RTS/CTS)
Select whether to enable serial port or not.
Protocol used in Serial to LAN communication.
Select Server or Client Mode.
Enter the IP address for WIZ630wi setting.
Enter the port number for remote serial data server host PC.
Description
Description
24