Information On Products From The Pcs 7-Add On Catalog - Siemens SIMATIC PCS 7 Service Manual

Introduction
2.5 Licensing with the Automation License Manager
Installed libraries
As of PCS 7 V8.0 , the following libraries are installed by default.
● PCS 7 Basic Library
● PCS 7 Advanced Process Library
Library required
NOTICE
Installation of the PCS 7 libraries from the folder "Additional Products" is required for the
software update without utilization of new functions.
Libraries that were supplied prior to PCS 7 V8.0 cannot be installed.
Result of the Software Update
Following the software update described here, the updated PCS 7 project will behave as it did
before the update. New functions can be implemented by performing additional steps.
For information on this, refer to the manual
With Utilization of the New Functions (PCS 7 as of V7.1.3 to V8.0 Update 1) .
2.4

Information on Products from the PCS 7-Add On Catalog

Important Information
If you used PCS 7 add-on products (software packages or hardware components) in your
process control system, contact your SIMATIC PCS 7 representative
2.5 Licensing with the Automation License Manager
Managing the License Keys
Both license keys and authorizations can be transferred using the Automation License
Manager. In the following, the term "license key" is always used even when a product uses
the old license scheme based on authorizations.
Different types of licenses are used in the Automation License Manager.
Each license consists of a basic license type and a license type.
12
Process Control System PCS 7; Software Update
Software update without utilization of new functions
Service Manual, 03/2012, A5E02779792-02