Introduction
2.2 General Requirements
2.2
General Requirements
The following requirements must be met regardless of whether you execute the software
update with or without the utilization of new functions:
General Requirements for Updating the Software
● Your PC hardware must meet the hardware requirements for PCS 7 V8.0 Update 1.
● A PC on which the PCS 7 software is to be installed must meet one of the following
● The project must be updated to PCS 7 V7.1 SP3 . The libraries supplied with PCS 7 V8.0
10
For more information, refer to the
System; SIMATIC PCS 7 DVD.
requirements:
– The PC can access a DVD drive via a network.
– It has its "own" DVD drive (example: USB DVD drive).
Note
You must complete the software update before beginning with any additional changes
to the configuration.
Update 1 can only control and monitor the AS blocks of the following PCS 7 versions:
– PCS 7 V6.1 SP4
– PCS 7 V7.1 SP3
– PCS 7 V8.0 xx
Note
If AS blocks from other PCS 7 versions are used in the project, it will be necessary to
update these blocks via a software update using new functions.
pcs7 readme documentation on the Process Control
Software update without utilization of new functions
Service Manual, 03/2012, A5E02779792-02