Updating Simatic Batch - Siemens SIMATIC PCS 7 Service Manual

Updating SIMATIC BATCH

Introduction
Note
Please observe the following when updating the software from PCS 7 V7.1 SP3 (with
SIMATIC BATCH V7.1 SP1) to PCS 7 V8.0 Update 1 (with BATCH V8.0 Update 1):
● To save the project "with reorganization", you first need to manually replace the BATCH
● Set the BATCH Start Coordinator to "Manual" start mode before you update the software.
It is essential that you observe these points when you prepare the software update. You can
find additional information on this topic in the section "Overview of preparations (Page 23)".
For more information on updating SIMATIC BATCH, refer to the following documentation:
●
● Manual
Software update without utilization of new functions
Service Manual, 03/2012, A5E02779792-02
application in the PC stations in HW Config.
SIMATIC BATCH Readme ; Part C1, Installation
Process Control System PCS 7; SIMATIC BATCH
10
63