Advertisement
AC Voltage bandwidth
Operating Temperature
Storage Temperature -14 to 140
Relative Humidity
Altitude
Over voltage
Battery
Auto OFF
Dimensions/Weight
Safety
Operation
NOTICES: Read and understand all warning and precaution statements listed in the safety section of this
operation manual prior to using this meter. Set the function select switch to the OFF position
when the meter is not in use.
AC Current Measurements
WARNING: Ensure that the test leads are
disconnected from the meter before making current clamp measurements.
1. Set the Function switch to the 1000A
Or 400A or 40A range. In case of unknown
Measurement, please select the higher range
First and then move to the lower range
if necessary.
2. Press the trigger to open jaw. Fully enclose
one conductor to be measured.
3. The clamp meter LCD will display the reading.
DC/AC Voltage Measurements
1. Insert the black test lead into the negative COM terminal and the red test lead into the positive V terminal.
2. Set the function switch to the V position.
3. Select AC or DC with the MODE button.
4. Connect the test leads in parallel to the circuit under test.
5. Read the voltage measurement on the LCD display.
Resistance and Continuity Measurements
Insert the black test lead into the negative COM terminal and the red test lead into the positive terminal.
1.
50~400Hz (VAC)
o
14 to 122
F (-10 to 50
o
F (-30 to 60
o
o
90%(0
C to 30
C); 75%(30
Operating: 3000m; Storage 10,000m
Category III 1000V
Category IV 600V
One "9V" Battery
approx. 30 minutes
For indoor use and in accordance with Overvoltage Category II, Pollution
Degree 2. Category II includes local level, appliance, portable equipment, etc.,
with transient overvoltages less than Overvoltage Cat. III
www.tmatlantic.com
o
C)
o
C)
o
o
C to 40
C); 45%(40
NO
MO DE
REL
RANG E
HO LD
5
o
o
C to 50
C)
YES
MO DE
Hz%
REL
RANG E
Hz%
HO LD
Advertisement
