1
1.6
Workpiece setup
Selecting the correct operating mode
Workpieces are set up in the Manual operation or Electronic
handwheel mode
Press the operating mode key
The control switches to the Manual operation
mode.
Further information on this topic
The operating mode Manual operation
Further information:
Clamping the workpiece
Mount the workpiece with a fixture on the machine table so that it
is fixed with its edges parallel to the machine axes.
Further information on this topic
Presetting with a 3-D touch probe
Further information:
number 17)", page 418
Presetting without 3-D touch probe
Further information:
page 403
76
"Moving the machine axes", page 380
"Presetting with a 3-D touch probe (option
"Presetting without a 3-D touch probe",
First Steps with the TNC 128 | Workpiece setup
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017