First Steps with the TNC 128 | Setting up tools
1.5
Setting up tools
Selecting the correct operating mode
Tools are set up in the Manual operation mode:
Press the operating mode key
The control switches to the Manual operation
mode.
Further information on this topic
Operating modes of the control
Further information:
Preparing and measuring tools
Clamp the required tools in their tool holders
When measuring with an external tool presetter: Measure the
tools, note down the length and radius, or transfer them directly
to the machine through a transfer program
When measuring on the machine: Insert the tool
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017
"Modes of operation", page 83
1
73