Table of Contents
Advertisement
First Steps with the TNC 128 | Setting up tools
The pocket table TOOL_P .TCH
Refer to your machine manual.
The function of the pocket table depends on the
machine.
In the pocket table TOOL_P .TCH (permanently saved under
TNC:\table\) you specify which tools your tool magazine contains.
To enter data in the pocket table TOOL_P .TCH, proceed as follows:
Display the tool table
The control shows the tool table.
Display the pocket table
The control shows the pocket table.
Edit the pocket table: Set the EDIT soft key to ON
With the upward or downward arrow keys you
can select the pocket number that you want to
edit
With the rightward or leftward arrow keys you
can select the data that you want to edit
To leave the pocket table, press the END key
Further information on this topic
Operating modes of the control
Further information:
Working with the pocket table
Further information:
page 199
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017
"Modes of operation", page 83
"Pocket table for tool changer",
1
75
Advertisement
Table of Contents
