Table of Contents
Advertisement
3
3.2
Creating and writing programs
Structure of an NC program in HEIDENHAIN Klartext
A machining program consists of a series of NC blocks. The
illustration on the right shows the elements of a block.
The control numbers the blocks of a part program in ascending
order.
The first block of a program is identified by BEGIN PGM, the
program name and the active unit of measure.
The subsequent blocks contain information on:
The workpiece blank
Tool calls
Approaching a safe position
Feed rates and spindle speeds, as well as
Movements, cycles and other functions
The last block of a program is identified by END PGM, the program
name and the active unit of measure.
Danger of collision!
The control does not automatically check whether collisions can
occur between the tool and the workpiece. There is danger of
collision during the approach movement after a tool change!
If necessary, program an additional safe auxiliary position
112
Fundamentals, File Management | Creating and writing programs
NOTICE
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017
Block
. ..
Words .
Block number
. .
.
Advertisement
Table of Contents
