Table of Contents
Advertisement
Fundamentals | Control model, software and features
Modified functions 77184x-03
FZ and FU feed rate input possible in the Tool Call block, see
"Calling the tool data", page 202
The input range of the DOC column in the pocket table has
been expanded to 32 characters, see "Pocket table for tool
changer", page 199
Commands FN 15, FN 31, FN 32, FT and FMAXT from
predecessor controls no longer generate ERROR blocks during
import. When simulating or running an NC program with these
commands, the control interrupts the NC program with an error
message that helps you to find an alternative implementation
The maximum file size of files output with FN 16: F-PRINT has
been increased from 4 KB to 20 KB
The Preset.PR preset management is write-protected in
Programming operating mode, see "Saving presets in the table",
page 396
The input range of the Q parameter list for defining the QPARA
tab on the status display consists of 132 input positions, see
"Displaying Q parameters (QPARA tab)", page 90
Manual calibration of the touch probe with fewer pre-positioning
movements, see "Calibrating 3-D touch probes (option 17)",
page 412
The position display takes into account the DL oversizes
programmed in the Tool Call block, selectable as an oversize of
the workpiece or tool, see "Delta values for lengths and radii",
page 187
In single block mode the control executes each point individually
with point pattern cycles and CYCL CALL PAT, see "Program
run", page 447
Rebooting the control is no longer possible with the END key
but with the RESTART soft key, see "Switch-off", page 379
The control displays the contouring feed rate in manual mode,
see "Spindle speed S, feed rate F and miscellaneous function
M", page 394
Deactivate tilting in manual mode is only possible via the 3D-
ROT menu, see "Activating manual tilting:"
Machine parameter maxLineGeoSearch (no. 105408) has
been increased to max. 50000, see "Machine-specific user
parameters", page 640
New and modified cycle functions 77184x-03
Cycle 253 SLOT MILLING has been added (option 19), see
"SLOT MILLING (Cycle 253, DIN/ISO: G253)", page 575
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017
13
Advertisement
Table of Contents
