Table of Contents
Advertisement
Introduction | Window manager
Remote Service
Together with the Remote Service Setup Tool, the TeleService from
HEIDENHAIN enables encrypted end-to-end connections to be
established between a service computer and the machine tool.
To enable the HEIDENHAIN control to communicate with the
HEIDENHAIN server it must be connected to the internet.
Further information:
"Configuring the control", page 486
In its basic state the firewall of the control blocks all incoming
and outgoing connections. For this reason the firewall must be
deactivated for the duration of the service session.
Setting up the control
To set up the control, proceed as follows:
Taskbar at the bottom edge of the screen
Further information:
Press the green HEIDENHAIN button to open the JH menu
Select the Settings menu item
Select the Firewall menu item
The control displays the Firewall/SSH settings dialog
Deactivate the firewall by removing the Active option in the
Firewall tab.
Press the Apply button to save the settings
Press the OK button
The firewall is disabled.
Do not forget to activate the firewall again after the end
of the service session.
Automatic installation of a session certificate
With an NC software installation a temporary certificate is
automatically installed on the control. An installation, also in the
form of an update, may only be carried out by a service technician
from the machine tool builder.
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017
"Window manager", page 91
2
95
Advertisement
Table of Contents
