Table of Contents
Advertisement
2
Test Run
In the Test Run mode of operation, the control checks NC
programs and program sections for errors, such as geometrical
incompatibilities, missing or incorrect data within the program
or violations of the working space. This simulation is supported
graphically in different display modes.
Soft keys for selecting the screen layout
Soft key
Window
Program
Left: program, right: status display
Left: program, right: graphics
Graphic
Program Run, Full Sequence and Program Run, Single
Block
In the Program Run Full Sequence mode, the control executes
a program continuously to its end or to a manual or programmed
stop. You can resume program run after an interruption.
In the Program Run Single Block mode, you execute each block
separately by pressing the NC start key. With point pattern cycles
and CYCL CALL PAT the controls stops after each point.
Soft keys for selecting the screen layout
Soft key
Window
Program
Left: program, right: structure
Left: program, right: status display
Left: program, right: graphics
Graphic
84
HEIDENHAIN | TNC 128 | Conversational Programming User's Manual | 10/2017
Introduction | Modes of operation
Advertisement
Table of Contents
