ABB REM 610 Technical Reference Manual page 90

REM 610
90
Motor Protection Relay
Technical Reference Manual
Table 4.1.15-9 Output signals
Status of the protection
stages
Start of stage I >
0
Trip of stage I >
0
Start of stage I >
2
Trip of stage I >
2
Trip of stage REV
External trip
Motor start up
Restart inhibit
Alarm of stage ThA>
Trip of stage ThA>
Alarm of stageThB>
Trip of stage ThB>
CBFP trip
Table 4.1.15-10 Outputs
Operation of output
contact
Output PO1
Output PO2
1)
Output PO3
Output SO1
Output SO2
Output PO3 (restart
3)
inhibit)
Enabling activation of
output contacts PO1,
PO2, PO3, SO1 and SO2
via the SPA bus
1)
State of output when the start, trip and alarm signals from the protection stages, the motor start-up
signal and the external trip signal have been routed to PO3 (SGR3/1...19=1), provided that SGF1/7=1.
2)
Either O43/O103 or O46 is to be used at a time.
3)
State of output when the restart inhibit signal have been routed to PO3 (SGF1/7=0).
Note!
Parameters O41...O46 and O51 control the physical output contacts which can be
connected to circuit breakers, for instance.
Parameters for the IEC 60870-5-103 remote communication
protocol
Table 4.1.15-11 Settings
Description
Unit address of the relay
Data transfer rate (IEC_103), kbps
Recorded
State of stage (R),
functions (R),
channel 0
channel 0
O10 O70
O11 O71
O12 O72
O13 O73
O14 O74
O15 O75
O16 O76
O17 O77
O18 O78
O19 O79
O20 O80
O21 O81
O22 O82
State of output Recorded
(R, W, P), functions (R),
channel 0 channel 0
O41 O101
O42 O102
O43 O103
O44 O104
O45 O105
O46
O51
Parameter
(channel 507)
507V200
507V201
1MRS 752263-MUM
Value
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0/1
Value
0/1
0/1
2)
0/1
0/1
0/1
-
2)
0/1
- 0/1
R, W, P Value
R, W 1...254
R, W (P) 9.6/4.8