DIP Switch
The front panel of the IGS-624HPT provides one 3-DIP Switch which is for
configuring 100 or 1000X fiber support and fiber redundant function.
Refer to the table below to know about the 3-DIP switch settings and descriptions:
For more information about the fiber redundancy function, please refer to the
chapter 2.1.7 Redundancy Overview.
Fiber Redundant (DIP 3)
Port 6 (DIP 2)
Port 5 (DIP 1)
2.1.2 LED Indicators
System
LED
Color
P1
Green
P2
Green
FAULT
Green
10/100/1000Base-T Interfaces
LED
Color
Green
LNK/ACT
Orange
PoE In-Use
Orange
(Port 1~4)
14
Light: indicates power 1 has power.
Light: indicates power 2 has power.
Light: indicates either power 1 or power 2 has no power.
Light: indicates the Switch is successfully connecting to
the network at 1000Mbps.
Blink: indicates that the Switch is actively sending or
receiving data over that port.
Off: indicates that the Switch is inactively sending or
receiving data over that port.
Light: indicates the Switch is successfully connecting to
the network at 10Mbps or 100Mbps.
Blink: indicates that the Switch is actively sending or
receiving data over that port.
Off: indicates that the Switch is inactively sending or
receiving data over that port.
Light: indicates the port is providing 52V DC in-line
power.
Off: indicates the connected device is not a PoE Powered
Device (PD).
OFF
Switch
Fiber Redundant
1000X
1000X
Function
Function
ON
100FX
100FX