DP CyberParallel Dual Quick Installation Guide Introduction The DP CyberParallel Dual is a high-speed parallel I/O card for parallel device connections. It provides 2 ECP/ EPP parallel ports which support data transfer rates up to 1.5 MB/s. Features and Benefits •...
Page 2
Package Contents • DP CyberParallel Dual • DB25 parallel port cable (for 2nd parallel port) • 2x spare low profile brackets • Driver CD • Quick installation guide Board Layout Stripe DB25 Parallel Parallel Port 2 (P2)* Port cable Parallel Port 1 (P1) Figure 1.
Hardware Installation Note: For low profile systems, replace the currently mounted bracket with the included low profile bracket. General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed.
Software Installation This section provides the steps on how to install the DP CyberParallel Dual drivers. Please make sure the board is installed before proceeding with the driver installation. Windows 8 (32-/64-bit) / 7 (32-/64-bit) / Server 2008 R2 Install the board and boot up Windows. Right click Computer, click Manage, click Device Manager.
Page 5
Click Don't search online. Skip this step if not prompted. Click I don't have the disc. Show me other options. Click Browse my computer for driver software. Insert the driver CD. Close the AutoPlay box if prompted. For 32-bit: Type D:\32bit, click Next. (Change D: to match your CD-ROM drive letter) For 64-bit: Type D:\64bit, click Next.
Page 6
Windows 2000 At the Found New Hardware Wizard, click Next. Select Search for a suitable driver for my device (recommended), then click Next. Select Specify the location, uncheck the other boxes, then click Next. Insert the driver CD, type in D:\2000, then click OK. (Change D: to match your CD-ROM drive letter) Click Next, then Finish to complete the installation.
Page 7
When Windows resumes the driver will install automatically. Click Yes to restart to complete the installation. Windows 95 At the Update Device Driver Wizard, click Next. Insert the driver CD. Click Other Locations. Type D:\ME, click OK, then click Finish. (Change D: to match your CD-ROM drive letter) At the Insert Disk window, click OK.
Page 8
To Verify Windows Installation Windows 8 (32-/64-bit) / 7 (32-/64-bit) / Windows XP (32- /64-bit) / Server 2003 (32-/64-bit) / 2000 Right click Computer or My Computer, click Manage, then click Device Manger. Double click Ports (COM & LPT), two PCI... Parallel Port...
SIIG will, at our discretion, repair or replace (with an identical product or product having similar features and functionality) the product if defective in materials or workmanship.
Page 12
Fremont, CA 94538-3152, USA Phone: 510-657-8688 DP CyberParallel Dual is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. All other names used in this publication are for identification only and may be trademarks of their respective owners.