Table of Contents
Advertisement
12.
13.
Using the Help System
For information about program features, you can access the help program in either of the
following ways:
From within the switcher control program, select
From within the switcher control program, press the <F1> key.
Button Label Generator Program
The Button Label Generator software creates labels that you can place in the translucent
covers of the input selection buttons. You can create labels with names, alphanumeric
characters, or even color bitmaps for easy and intuitive input and output selection.
Labels" on page 24 documents the procedure for removing and replacing the translucent
covers.
The Extron Button Label Generator is available on the Extron website, www.extron.com,
under the
the program.
Figure 17.
NOTES: • When downloaded from the Extron website, the firmware is placed in a
subfolder of
C:\Program Files\Extron\Firmware
• Valid firmware files must have the file extension .S19. A file with any
other extension is not a firmware upgrade.
• The original factory-installed firmware is permanently available on the
switcher. If the attempted firmware upload fails for any reason, the
switcher reverts to the factory-installed firmware.
In the Firmware Loader window, click
The
and
Total Progress
Progress
upload may take several minutes. Once the status bars have progressed from
, and Status is listed as
100%
Figure 16.
Firmware Loader Screen
Click
to close the Firmware Loader.
Exit
tab. Click the
Download
Extron Download Center
(see figure 16).
Begin
status bars show the upload progress. The firmware
, the firmware loader utility resets the switcher.
Completed
>
Help
Contents
link (see figure 17), and download and install
Software
.
0%
to
12
on the task bar.
"Button
FOX SW8 • Remote Control
19
Advertisement
Table of Contents
