Table of Contents
Advertisement
Installation and
Operation
The topics covered in this section are:
•
•
•
Rear Panel Connections
Figure 2.
WARNING:
NOTES:
Rear Panel Connections
Front Panel Configuration Port
Controls, Indicators, and Operation
2
2
100-240V
0.3A
1
2
LOOP IN
LOOP IN
50/60 Hz
1
3
3
FOX SW8 Connectors
Risk of serious physical injury: The FOX SW8 outputs continuous
invisible light, which may be harmful to the eyes; use with caution.
•
Do not look into the rear panel fiber optic cable connectors or into
the fiber optic cables themselves.
•
Plug the attached dust caps into the optical transceivers when the fiber
cable is unplugged.
•
Singlemode and multimode devices are not interchangeable. Ensure that
you connect transmitting and receiving devices that are compatible with the
FOX SW8.
•
Ensure that you use the proper fiber cable for your system. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange or
aqua jacket.
•
In this guide, the term "sending connector" refers to an LC connector on a
device that outputs a fiber optic signal. The term "receiving connector" refers
to an LC connector that receives an optical signal.
2
2
2
2
OPTICAL INPUTS
3
4
5
6
LOOP IN
LOOP IN
LOOP IN
LOOP IN
3
3
3
3
FOX SW8 • Installation and Operation
2
2
FOX SW8
7
8
LOOP IN
OUT
IN
RS-232
Tx Rx
3
4
5
4
Advertisement
Table of Contents
