Table of Contents
Advertisement
a
AC power connector — Plug a standard IEC power cord into this connector to connect
the FOX SW8 to a 100 VAC to 240 VAC, 50-60 Hz power source.
b
Input connectors and LEDs —
Connectors — For one-way video, audio, and serial
communications from the transmitter to the FOX SW8
(to be switched to the receiver) connect up to eight fiber
optic cables to the input (right-hand) LC connector on
the optical transceiver blocks.
Connect the far end of these fiber optic cables to
the sending connectors on the transmitters or other
compatible Extron devices.
LEDs — When lit, the link is active (light is received from
the transmitter).
NOTE:
The right-hand LEDs for transceiver blocks 2,
4, 6, and 8 may light, but do not indicate an
input to that connector.
c
Loop connectors and LEDs —
Connectors — For unswitched (input 1 loops through
to output 1, input 2 to output 2, and so on), one-way
video, audio, and serial communications, looped through
from the switcher, connect fiber optic cables to the Loop
(left-hand) LC connectors on transceiver blocks 1 through 7.
Connect the far ends of these fiber optic cables to the
receiving connectors on the receivers or other compatible
Extron devices.
LEDs — These LEDs are always lit (light is always output
to these connectors).
d
Output connector and LED —
Connector — For the switched output one-way video,
audio, and serial communications, connect a fiber optic cable to the Output (left-hand)
LC connector on transceiver block 8.
Connect the far end of this fiber optic cable to the receiving connector on the receiver
or other compatible Extron device.
LED — This LED is always lit (light is always output on this connector).
Transmitter
#7
OPTICAL
1
2*
*
OPTIONAL FOR
RETURN DATA
2
7
LOOP IN
3
Receivers
OPTICAL
2*
1
Local (Loop)
Application
FOX SW8 • Installation and Operation
Transmitter
#8
OPTICAL
1
2*
*
OPTIONAL FOR
RETURN DATA
8
OUT
IN
Switcher
4
OPTICAL
2*
1
Switched
Application
5
Advertisement
Table of Contents
