Install Operation Instruction Placard - Hunter DSP9600 Installation Instructions Manual

NOTE:
19. Lift the end of the beam slightly when tightening the bolts to close the gap between beam mounting plate and
the attachment blocks.
NOTE:
20. To verify proper operation of the wheel lift assembly, remove the tire/wheel assembly from the trolley, raise
the wheel lift, and then close the hood of the balancer. Lifting beam and trolley should lower automatically.

Install Operation Instruction Placard:

1. Flip the placard hanger, 117-193-1-002, forward.
2. Open a split ring, 223-74-2, and insert it through both small holes on the left side of the placard hanger. Slide
the left holes of the placard, 214-121-2, over the split ring, and then close the split ring. Verify that the hinge
of the split ring is located on the backside of the placard hanger.
3. Open a split ring and insert it through both small holes in the center of the placard hanger. Slide the center
holes of the placard over the split ring and then close the split ring. Verify that the hinge of the split ring is
located on the backside of the placard hanger.
4. Open a split ring and insert it through both small holes on the right side of the placard hanger. Slide the right
holes of the placard over the split ring and then close the split ring. Verify that the hinge of the split ring is
located on the backside of the placard hanger.
5. Return the placard to its storage position behind the display when not in use.
IN USE POSITION
It may be necessary to remove the tire/wheel assembly from the trolley to
move the beam. However, the mounting position of the beam must be
verified with the tire/wheel assembly in place.
Ensure that the four bolts securing the beam's mounting plate to the
attachment blocks are completely tightened.
17
PLACARD HANGER,
117-193-1-002
SPLIT RING,
223-74-2
HINGE
PLACARD,
214-121-2
STORAGE POSITION