Working With The Stud Welder; Safety Instructions For Maintenance, Inspection And Assembly Works; Unauthorized Retrofit And Spare Parts Production - Soyer BMS-8N Operating Instructions Manual

R

3.9 Working with the stud welder

3.10Safety instructions for maintenance, inspection and assembly
works
Only carry out maintenance
works when stud welder has
been switched off

3.11Unauthorized retrofit and spare parts production

Revision 1
• Comply with all accident prevention regulations which apply to the operation
of your stud welder
One of the accident prevention regulations applicable for stud
welders is VBG15 "Welding , cutting and similar working
methods". For more information, contact the Employer's Liability
Insurance Association.
MORTAL DANGER
When welding, do not wear clothes soiled with easily combustible
substances such as oil, grease and paraffin oil, etc.
If an accident happens,
• switch off the stud welder and disconnect it from the mains supply
• call a doctor.
The user must ensure that all maintenance, inspection and assembly
works are only carried out by authorized and qualified technical personnel.
Generally, only work at the system when it has been switched off and after
having disconnected it from the mains supply. It is indispensable to comply
with the procedure for stopping the stud welding system described in the
operating instructions (chapter 3.13).
Immediately after having completed your work, re-install and activate all safety
and protective devices.
The system may only be retrofitted and modified after consultation with the
manufacturer. Original spare parts and accessories authorized by the manufac-
turer guarantee safety. The use of other parts may result in the cancellation of
warranty for any consequences thus caused.
Safety instructions
3-13