Table of Contents
Advertisement
SPECIFICATIONS (CONTINUED)
Bundle Cutting (W x H)
Cut off Length
Cutting Amount Setting
Feeding Stroke
Minimum Material
Table Height
Dimensions (L x W x H)
Weight (lbs)
ASSEMBLY/INSTALLATION
• In the event of incorrect operation or dangerous
conditions, the machine may be stopped immediately
by pressing the red emergency shut off button.
• The casual or voluntary removal of the flywheel
covers causes a micro-switch activation that
automatically stops all machine functions.
NOTE: Resetting of machine operation after each
emergency stop requires specific restart button.
Machine dimensions
87.2"
Environmental and installation requirements
•
The electrical supply must comply with the machine's motor
requirements.
•
Environment temperature should fall within 14°F to +122°F.
•
Relative humidity cannot be over 90%.
6" to 9-3/4" x 4" to 5"
0.39"
1 - 9999
15-3/4"
1-1/4"
29-1/2"
87" x 90-5/32" x 74-13/32"
3,725
55.1"
80.3"
Securing the machine to the foundation
•
Position the machine on a flat and level foundation of
reinforced concrete. The foundation must be strong enough to
support the weight of the machine.
•
Anchor the machine to the foundation with anchor bolts.
Maintain a minimum distance of 32" from the rear of the
machine to the wall. Position the anchors using screws and
expansion plugs or tie rods sunk in cement.
Leveling the machine
The operating accuracy of all precision machinery depends on
the installation of the machine. Manufacturing tolerances can
only be guaranteed if the machine is installed properly onto a
solid foundation.
Once the machine is lowered on the prepared foundation,
machinist levels should be used alternately on the vise slide
plates and work feed table. Adjust the left to right and front to
back leveling of the machine with leveling bolts. All leveling bolts
should support the machine evenly.
Machine deactivation
If the machine is to be out of use for a long period of time, the
following procedures are highly recommended:
•
Disconnect the machine from the power supply.
•
Loosen the tension on the blade.
•
Empty the coolant tank.
•
Carefully clean and grease the machine.
•
Cover the machine.
OPERATION
The operation of any power tool can result
in foreign objects being thrown into the
eyes, which can result in severe eye damage. Always wear
safety goggles complying with United States ANSI Z87.1.
Keep your hands away from all cutting
edges and moving parts. Never reach
under the saw. The blade is exposed in these areas and the
guards cannot protect your body there.
The automatic vise clamps on this
machine exert great pressure on the
clamped workpieces when they are activated. Use extreme
caution when placing, positioning and clamping stock with
the vise clamps.
In case of an emergency situation
Push the emergency shut off button down to stop
all functions. To release the emergency shut off
button rotate the mushroom shaped button clock-
wise. The button will pop up and the cutting cycle
can be restarted.
5
Advertisement
Table of Contents
