Grizzly G0776 Owner's Manual page 90

3. Loosen motor mount bolts (Figure 148) and
remove belts.
Pulley
Cap
Screw
Figure 148. Pulley cap screw.
4.
Have another person step on brake pedal to
lock pulley in place, and remove pulley cap
screw shown in Figure 148.
5. Step off brake pedal and remove pulley.
Figure 149 shows pulley removed and brake
shoes exposed.
E-Clip
Figure 149. Brake assembly.
-88-
Motor
Mount
Bolts
Brake
linings
Springs
6. Using your calipers, measure thickness of
brake linings.
— If linings are thicker than
earlier, then replacement is not required.
Re-assemble lathe in the opposite manner
as outlined in Steps 2–5.
—If linings are oil-soaked from over lubrica-
tion of adjacent gearing, clean and properly
lubricate gears as outlined in Maintenance
on Page 69. Then proceed to Step 7.
—If brakes linings are
to Step 7.
7.
Put on safety glasses and remove E-clip,
springs, and brake shoes shown in Figure
149.
8.
Replace or dress drum pulley as required.
9. Install brake shoes, springs, and E-clip.
10. Install pulley and re-assemble in opposite
manner that you disassembled it in Steps
2–5.
11. Start lathe and test brake operation.
Model G0776 (Mfd. Since 7/14)
⁄ " as described
3
16
⁄ " or thinner, proceed
3
16