Grizzly G0776 Owner's Manual page 56

5. Loosen 120T/127T gear support hex nut and
slide the middle gear away from the lower "Z"
position gear, as shown in Figure 77.
Upper
Position Gear
127T Gear
120T Gear
Arm-Support
Hex Nut
Figure 77. End gear placement.
6.
Remove cap screw and flat washer from
upper position and "Z" position gears, then
slide gears off of shafts.
7. Slide 24T gear onto upper position shaft and
48T gear onto 'Z" position shaft, making sure
to align keys and keyways.
Note: Position flat, non-stepped face of gears
away from the headstock so they will mesh
with the 127T gear in Step 11.
8. Secure 24T and 48T gears with flat washers
and cap screws removed earlier.
-54-
9.
Gear-Support
Hex Nut
127T Gear
120T Gear
"Z"
Position Gear
10. Rotate 127T gear up against 24T gear until
11. Tighten arm support hex nut.
12. Re-install the end gear cover.
Slide 127T gear against lower 48T gear (see
Figure 78) until they mesh with 0.002" to
0.004" backlash, then tighten gear support
hex nut.
24T Gear
Arm-Support
Hex Nut
Figure 78. 60T & 54T gears installed.
they mesh with 0.002" to 0.004" backlash.
Model G0776 (Mfd. Since 7/14)
Gear-Support
Hex Nut
48T Gear