Grizzly G0776 Owner's Manual page 71

E
D
H
Figure 121. Handwheel ball oilers.
Figure 124. End cap ball oilers.
F
End Gears
Grease Type ........ T23964 or NLGI#2 Equivalent
Lubrication ................. Every 50 Operating Hours
The end gears, shown in Figure 125, should
always have a thin coat of heavy grease to
minimize corrosion, noise, and wear. Wipe away
excess grease that could be thrown onto the
V-belts and reduce optimal power transmission
from the motor.
Figure 122. Tailstock ball oilers.
G
Figure 125. End gears.
Figure 123. Change gear hub ball oiler.
Handling & Care
Make sure to clean and lubricate any gears you
install or change. Be very careful during handling
and storage—the grease coating on the gears will
easily pickup dirt or debris, which can then spread
to the other gears and increase the rate of wear.
Make sure the end gear cover remains closed
whenever possible to keep the gears free of dust
or debris from the outside environment.
-69-
Model G0776 (Mfd. Since 7/14)