Installation Of Multiple Sensors (Digital And Analog, Address Mode); Installation Of Multiple Sensors (Digital And Analog, Tag Mode) - RayTek TX Operating Instructions Manual

4.5.6 Installation of Multiple Sensors (digital and analog, address mode)




HART/RS232
Adapter
Monitor
Figure 15: All sensors in digital communication, first sensor also with analog current output
When installing a number of sensors, note that each sensing head must first be assigned a separate
polling address (0 to 11), section 4.5.4

4.5.7 Installation of Multiple Sensors (digital and analog, tag mode)

To run a sensor with analog current output, the sensor is to address with polling address 0. In case of
having multiple sensors running with analog current output, the polling address can not be the criteria
to distinguish between the sensors, because every sensor would be set to the same address. To avoid
this, a sensor can be named by means of a so called tag. The tag will be stored within the units memory
and can later be used to identify the sensor uniquely.
TX
info@Raytek-Direct.com
Maximum 12 sensors can be used.
Analog and digital communication for the sensor with polling address 0.
Communication for the remaining 11 sensors purely digital.
Shield (6)
The sensing heads are factory-programmed with "Polling Address 0"!
Sensors Voltage [V] Op. Current [mA]
1
2
3
4
5
6
7
8
9
10
11
12
Address Assignment for Multiple Sensors
Rev. O7 07/2017
Installation
P S
OWER UPPLY
24 23
24 27
24 31
24 35
24 39
24 43
24 47
24 51
28 55
28 59
!
28 63
28 67
on page 21).
1.888.610.7664
23