Sensor Setup - RayTek TX Operating Instructions Manual

Software
Figure 32: List of Found Devices

7.3 Sensor Setup

Selecting <Sensor Setup> from the <Setup> displays a list of attached sensors. When you select one, a
screen similar to the following displays.
In the <Sensor Setup> screen, you may configure the settings for the signal processing (emissivity,
ambient control, hold modes, fail safe mode), the output signals (alarms and relay), and the advanced
setup (polling address, descriptions).
Figure 33: <Sensor Setup> Menu
See the DataTemp Multidrop software help for further instructions!
38 TX
info@Raytek-Direct.com 1.888.610.7664
Rev. O7 07/2017