Component Identification; Installation; Terminal Connections - M-system R1M-A1 Instruction Manual

COMPONENT IDENTIFICATION

■ REAR VIEW
RS-232-C
9-pin Connector
Power Terminals
RS-485 Node Address Setting
Connector Rotary SW
Specifications

TERMINAL CONNECTIONS

Connect the module referring to the connection diagram.
■ EXTERNAL DIMENSIONS unit: mm (inch)
• M3 SCREW TERMINALS
• FCN TYPE CONNECTOR
Connector Pin
Assignment
A1 B1
FCN TYPE INPUT CONNECTOR
A16 B16
RUN Indicator
LED
Configurator
Jack
175 (6.89)
165 (6.50)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 35
163 (6.42)
FOR WALL MOUNT.
6.2 (.24)
36–M3 INPUT TERMINALS
175 (6.89)
165 (6.50)
CN1
163 (6.42)
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp

INSTALLATION

■ DIN RAIL MOUNTING
Set the body so that its DIN rail
adaptor is at the bottom. Pull
down the DIN rail adaptor.
Position the upper hook at the
rear side on the DIN rail and
push in the lower. Push back the
DIN rail adaptor.
■ WALL MOUNTING
Set the body so that its DIN rail
adaptor is at the bottom. Pull
down the DIN rail adaptor.
Refer to "EXTERNAL DIMENSIONS."
3–5 (.20) dia.
MTG HOLES
T5 T6 T7
T1 T2 T3 T4
3–5 (.20) dia.
MTG HOLES
T5 T6 T7
T1 T2 T3 T4
CN2
See Caution below
FOR WALL MOUNT.
Caution: DO NOT APPLY EXCESSIVE FORCE onto
the connector. The connector may be destroyed.
DIN Rail
35mm wide
DIN Rail Adaptor
15.5 (.61)
DIN RAIL
35 mm wide
3 (.12)
40 (1.57) [6 (.24)]
40 (1.57)
15.5 (.61)
DIN RAIL
35 mm wide
3 (.12)
40 (1.57) [6 (.24)]
EM-5661 Rev.6 P. 2 / 8
R1M-A1