Management Interfaces; Interface (External Management); Sd Card Interface - Hirschmann EAGLE20 User Manual

1.8

Management interfaces

1.8.1 V.24 interface (external management)
Note: For information about the position on the device see
page 19.
A serial interface is provided on the RJ11 socket (V.24 interface) for the local
connection of an external management station (VT100 terminal or PC with
corresponding terminal emulation). This enables you to set up a connection
to the Command Line Interface CLI and to the System Monitor.
VT 100 terminal settings
Speed
Data
Stopbit
Handshake
Parity
The socket housing is electrically connected to the front panel of the device.
The V.24 interface is electrically insulated from the supply voltage.
RJ11
6
1
Figure 1: Pin assignment of the V.24 interface and the DE9 connector
You find the order number for the terminal cable, which is available as
accessory, under
1.8.2

SD card interface

Note: For information about the position on the device see
page 20.
The SD card interface allows you to connect the AutoConfiguration Adapter
ACA31 storage medium. This is used for saving/loading the configuration
data and diagnostic information, and for loading the software.
The ACA31 supports the FAT16 file system format exclusively.
Installation EAGLE20/30
Release 09 10/2015
9600 Baud
8 bit
1 bit
off
none
DE9
5
8
1
"Accessories" on page
RJ11
CTS 1
n.c. 2
TX 3
GND 4
RX 5
RTS 6
54.
"Front view" on
DE9
2
3
5
"Rear view" on
27