Identifier
Status
Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Identifier
Status
Procedure
NOTE: Ensure that the hinges are opened to the maximum before replacing
the display assembly on the palm-rest and keyboard assembly.
1
Place the palm-rest and keyboard assembly under the hinges on the display
assembly.
2
Press the hinges down on the system board and I/O board.
3
Replace the four screws (M2.5x4) that secure the left and right hinges to the
system board and I/O board, ensuring they are aligned with the screw holes on
the alignment posts.
4
Connect the display cable to the system board.
5
Route the antenna cables through the routing guides on the fan.
Identifier
Status
Post-requisites
1
Replace the
wireless
64
GUID-2DF70EB1-9D26-4051-8B7C-FB14A89925D8
Released
computer. After working inside your computer, follow
After working inside your
GUID-D4C84B92-8049-4863-B02B-F1EB227D8C77
Released
GUID-CFA00B8E-6DC6-420A-8C89-EB3D66C287DD
Released
card.
computer. For more safety best
www.dell.com/
Before