Airports - Garmin G950 Pilot's Manual

FLIGHT MANAGEMENT
Identifier with
Duplicates
Duplicate Message

AIRPORTS

'North Up' orientation on the Airport Information Page cannot be changed; the pilot needs to be
NOTE:
aware of proper orientation if the Navigation Map orientation is different from the Airport Information Page
Map.
The Airport Information Page is the first page in WPT group and allows the pilot to view airport information,
load frequencies (COM, NAV, and lighting), review runways, and review instrument procedures that may be
involved in the flight plan. See the Audio Panel and CNS Section for more information on loading frequencies
(auto-tuning). After engine startup, the Airport Information Page defaults to the airport where the aircraft is
located. After a flight plan has been loaded, it defaults to the destination airport. On a flight plan with multiple
airports, it defaults to the airport which is the current active waypoint.
In addition to displaying a map of the currently selected airport and surrounding area, the Airport Information
Page displays airport information in three boxes labeled 'AIRPORT', 'RUNWAYS', and 'FREQUENCIES'. For
airports with multiple runways, information for each runway is available. This information is viewed on the
Airport Information Page by pressing the INFO Softkey.
152
Figure 5-30 Waypoint Information Window - Duplicate Identifier
Garmin G950 Pilot's Guide for the Tecnam P2006T
Duplicate
Waypoints
190-01146-00 Rev. A