Garmin G950 Pilot's Manual page 77

OBS MODE
VNV is inhibited while automatic waypoint sequencing has been suspended.
NOTE:
Enabling Omni-bearing Selector (OBS) Mode suspends the automatic sequencing of waypoints in a GPS
flight plan (GPS must be the selected navigation source), but retains the current "active-to" waypoint as the
navigation reference even after passing the waypoint. 'OBS' is annunciated to the lower right of the aircraft
symbol when OBS Mode is selected.
While OBS Mode is enabled, a course line is drawn through the "active-to" waypoint on the moving map.
If desired, the course to/from the waypoint can now be adjusted. When OBS Mode is disabled, the GPS flight
plan returns to normal operation with automatic sequencing of waypoints, following the course set in OBS
Mode. The flight path on the moving map retains the modified course line.
Extended
Course
Enabling/disabling OBS Mode while navigating a GPS flight plan:
1) Select the OBS Softkey to select OBS Mode.
2) Turn the CRS Knob to select the desired course to/from the waypoint. Press the CRS Knob to synchronize the
Selected Course with the bearing to the next waypoint.
3) Select the OBS Softkey again to return to automatic waypoint sequencing.
190-01146-00 Rev. A
GPS
Selected
Line
Selecting the OBS
Softkey Suspends
Waypoint Sequencing
Figure 2-30 Omni-bearing Selector (OBS) Mode
Garmin G950 Pilot's Guide for the Tecnam P2006T
OBS Mode
Enabled
FLIGHT INSTRUMENTS
Selecting the OBS
Softkey Again
Returns to Normal
Operation
65