Garmin G950 Pilot's Manual page 70

FLIGHT INSTRUMENTS
TURN RATE INDICATOR
The Turn Rate Indicator is located directly above the rotating compass card. Tick marks to the left and right
of the lubber line denote half-standard and standard turn rates. A magenta Turn Rate Trend Vector shows the
current turn rate. The end of the trend vector gives the heading predicted in 6 seconds, based on the present
turn rate. A standard-rate turn is shown on the indicator by the trend vector stopping at the standard turn
rate tick mark, corresponding to a predicted heading of 18˚ from the current heading. At rates greater than 4
deg/sec, an arrowhead appears at the end of the magenta trend vector and the prediction is no longer valid.
BEARING INFORMATION
When the Arc HSI is displayed, the Bearing Information windows and pointers are disabled.
NOTE:
Two bearing pointers and associated information can be displayed on the HSI for NAV, GPS and sources.
The pointers are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective
information window to indicate the pointer type. The bearing pointers never override the CDI and are
visually separated from the CDI by a white ring (shown when bearing pointers are selected but not necessarily
visible due to data unavailability).
DME Information Window
(optional)
Distance to
Bearing Source
Bearing Pointer
Source Icon
Bearing 1 Information Window
58
Half-standard
Turn Rate
Standard
Turn Rate
Figure 2-21 Turn Rate Indicator and Trend Vector
Tuning Mode
Frequency
Distance
Station
Identifier
Figure 2-22 HSI with Bearing and DME Information
Garmin G950 Pilot's Guide for the Tecnam P2006T
Arrow Shown
for Turn Rate
> 4 deg/sec
Bearing 2 Bearing 1
Pointer
Pointer
Station
Identifier
Bearing 2 Information Window
Distance to
Bearing Source
Pointer Bearing
Icon Source
190-01146-00 Rev. A