Using The Remote Control In Wired Operation - NEC PH3501QL User Manual

Using the Remote Control in Wired Operation

Connect one end of the remote cable to the REMOTE terminal and the other end to the remote jack on the remote
control.
NOTE:
• When a remote cable is inserted into the REMOTE terminal, the remote control does not work for infrared wireless communication.
• Power will not be supplied to the remote control by the projector via the REMOTE jack. Battery is needed when the remote control
is used in wired operation.
• When [HDBaseT] is selected in the [REMOTE SENSOR] and the projector is connected to a commercially-available transmission
device that supports HDBaseT, remote control operations in infra-red cannot be carried out if transmission of remote control
signals has been set up in the transmission device. However, remote control using infrared rays can be carried out when the
power supply of the transmission device is switched off.
REMOTE
15
1. Introduction
Remote Jack