NEC PH3501QL User Manual page 132

Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn off (at the selected time: 0:05, 0:10,
0:15, 0:20, 0:30, 1:00) if there is no signal received by any input or if no operation is performed.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down and it is displayed at the bottom of the On-Screen Menu.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES] message will be displayed on the bottom of the screen.
Setting for the Optional Board [SLOT POWER]
When using the optional board installed in the slot, set the following options.
PROJECTOR ON .... This feature will turn on or off the power to the optional board.
OFF: Forcibly turn off the power to the optional board installed in the slot.
ON: Turn on the power to the optional board installed in the slot.
PROJECTOR STANDBY
.............................. This feature will automatically enable or disable the optional board installed in the slot when the projector
is in standby.
DISABLE: Select this option to disable the optional board in the projector standby.
ENABLE: Select this option to enable the optional board in the projector standby.
115
5. Using On-Screen Menu