NEC PH3501QL User Manual page 93

Cutting a signal from the Entry List [
1. Press the ▲ or ▼ button to select a signal you wish to delete.
2. Press the ◀, ▶, ▲, or ▼ button to select [
The signal will be deleted from the Entry List and the deleted signal will be displayed on the clipboard at the bot-
tom of the Entry List.
NOTE:
• The currently projected signal cannot be deleted.
• When the locked signal is selected, it will be displayed in gray which indicates it is not available.
TIP:
• Data on the clipboard can be passed onto the Entry List.
• Data on the clipboard will not be lost after the Entry List is closed.
Copying and pasting a signal from the Entry List [
1. Press the ▲ or ▼ button to select a signal you wish to copy.
2. Press the ◀, ▶, ▲, or ▼ button to select [
The copied signal will be displayed on the clipboard at the bottom of the Entry List.
3. Press the ◀ or ▶ button to move to the list.
4. Press the ▲ or ▼ button to select a signal.
5. Press the ◀, ▶, ▲, or ▼ button to select [
Data on the clipboard will be pasted to the signal.
Deleting all the signals from the Entry List [
1. Press the ◀, ▶, ▲, or ▼ button to select [
The confirmation message will be displayed.
2. Press the ◀ or ▶ button to select [YES] and press the ENTER button.
NOTE: The locked signal cannot be deleted.
Using Test Pattern [TEST PATTERN]
Displays the test pattern for adjusting distortion on the screen and the focus at the time of the projector setup. Once
the [TEST PATTERN] on the onscreen menu is selected, the pattern for adjustment will be displayed on. If you find
distortion on the pattern, adjust the projector installation angle or correct distortion by pressing the Geometric. button
on the remote. If the focus adjustment is required, press the FOCUS button on the remote control for displaying the
FOCUS adjustment screen and then adjust FOCUS by ◀ or ▶ button. Recommend to perform the focus adjustment
after leaving the projector under the state the TEST PATTERN has been projected for over 30 minutes. Press EXIT
button to close the test pattern and return to the menu.
(CUT)]
(CUT)] and press the ENTER button.
(COPY)] / [
(COPY)] and press the ENTER button.
(PASTE)] and press the ENTER button.
(ALL DELTE)]
(ALL DELETE)] and press the ENTER button.
76
5. Using On-Screen Menu
(PASTE)]