❼ About The Ascii Control Command - NEC PH3501QL User Manual

❼ About the ASCII Control Command
This device supports the common ASCII Control Command for controlling our projector and monitor.
Please visit our web site for detailed information about the command.
http://www.nec-display.com/dl/en/pj_manual/lineup.html
HOW TO CONNECT WITH AN EXTERNAL DEVICE
There are two methods to connect the projector with an external device such as a computer.
1. Connection thru the serial port.
Connects the projector to a computer by a serial cable (straight cable).
2. Connection via network (LAN/HDBaseT)
Connects the projector to a computer by a LAN cable.
Concerning to the type of LAN cable, please ask to your network administrator.
CONNECTION INTERFACE
1. Connection thru the serial port.
Communication Protocol
Item
Baud rate
Data length
Parity bit
Stop bit
Flow control
Communications procedure
2. Connection via network
Communication Protocol (Connection via LAN)
Item
Communication speed
Supported standard
Use the TCP port number 7142 for transmitting and receiving command.
Communication Protocol (Connection via HDBaseT)
Item
Communication speed
Supported standard
Use the TCP port number 7142 for transmitting and receiving command.
Information
115200/38400/19200/9600/4800 bps
8 bits
No parity
1 bit
None
Full duplex
Information
Set automatically (10/100 Mbps)
IEEE802.3 (10BASE-T)
IEEE802.3u (100BASE-TX, Auto-Negotiation)
Information
100 Mbps
IEEE802.3u (100BASE-TX, Auto-Negotiation)
144
8. Appendix