Battery Installation; Remote Control Precautions; Operating Range For Wireless Remote Control; Using The Remote Control In Wired Operation - NEC MT1065 User Manual

Battery Installation

1. Press firmly and slide the battery cover off.
2. Remove both old batteries and install new ones (AA). Ensure that
you have the batteries' polarity (+/-) aligned correctly.
3. Slip the cover back over the batteries until it snaps into place. Do not
mix different types of batteries or new and old batteries.
Note on Remote Control Operation:
If you press and hold the SELECT
batteries, the remote control may fail to work properly.
Should this happen, remove the batteries and then install them again
without touching the SELECT button.

Remote Control Precautions

• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the
• Do not place the batteries upside down.
• Do not use new and old batteries together, or use different types of

Operating Range for Wireless Remote Control

• The infrared signal operates by line-of-sight up to a distance of about
button while installing new
• The projector will not respond if there are objects between the re-

Using the Remote Control in Wired Operation

Connect one end of the supplied remote cable to the REMOTE mini
jack and the other end to the remote jack on the remote control.
E-11
batteries.
batteries together
7m/22 feet
22 feet/7 m and within a 60-degree angle of the remote sensor on the
projector cabinet.
mote control and the sensor, or if strong light falls on the sensor.
Weak batteries will also prevent the remote control from properly
operating the projector.
Remote sensor on the
projector cabinet
7m/22 feet
Remote control
Remote sensor on the
projector cabinet
REMOTE
OFF ON
POWER
VIDEO RGB VIEWER
AUTO ADJ. LASER
ASPECT FREEZE 3D REFORM
HELP POINTER PIC-MUTE
VOLUME MAGNIFY SLIDE
ZOOM FOCUS FOLDER
SLIDE
LIST