Adjustment; Packaging, Transport And Storage - Vega VEGAWELL 52 Operating Instructions Manual

3 Product description
Seal concept
Voltage supply
Packaging
Transport
Transport inspection
10
tance change in the measuring cell via the ceramic diaphragm. This
change is converted into an appropriate output signal.
As a standard feature, the CERTEC
a lateral, recessed seal.
Instruments with double seal have an additional front seal.
Fig. 3: Front-flush installation of the CERTEC
1 Housing, sensor
2 Measuring cell
3 Lateral seal for measuring cell
4 Additional, front seal for measuring cell
5 Diaphragm
4 ... 20 mA two-wire electronics for voltage supply and measured
value transmission on the same cable.
The data for power supply are specified in chapter "Technical data".
3.3

Adjustment

VEGAWELL 52 with 4 ... 20 mA electronics has no adjustment op-
tions.
3.4

Packaging, transport and storage

Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
measuring cell is equipped with
®
1
2
3
4
5
measuring cell with double seal
®
VEGAWELL 52 • 4 ... 20 mA