Normal Display Settings - Water Depot Deluxe Series Owner's Manual

NORMAL DISPLAY SETTINGS

GENERAL OPERATION
When the system is operating, one of six displays may be
shown. Pressing NEXT will alternate between the displays.
One of the displays is always the current time of day. The
second display is one of the following: days remaining or
volume remaining. Days remaining is the number of days
left before the system goes through a regeneration cycle.
Capacity remaining is the gallons that will be treated
before the system goes through a regeneration cycle. The
third display shows the current treated water flow rate
through the system. The fourth display shows the total
amount of treated water from 1x1000 to 9999x1000
gallons. This is resettable by simultaneously pressing the
clock and regen buttons for 3 seconds. The fifth display
will show either "dP" or "HoLd" if the dP switch is closed.
The sixth display indicates the user should call for service.
The sixth display will not appear if OFF is selected in Step
12S of OEM System Setup. To clear the Service Call
reminder, press the ▲ and ▼ buttons simultaneously
while CALL is displayed. If a water meter is installed, the
word "Softening" or "Filtering" flashes on the display when
water is being treated (i.e. water is flowing through the
system).
16