Installation - Water Depot Deluxe Series Owner's Manual

The control valve, fittings and/or bypass are designed to accommodate minor plumbing misalignments but are not
designed to support the weight of a system or the plumbing.
Do not use Vaseline, oils, other hydrocarbon lubricants or spray silicone anywhere. A silicone lubricant may be used
on black o-rings, but is not necessary. Avoid any type of lubricants, including silicone, on red or clear lip
seals.
Do not use pipe dope or other sealants on threads. Teflon tape must be used on the threads of the 1" NPT
elbow, its ˘" NPT connection, and on the threads for the drain line connection. Teflon tape is not used on the nut
connections or caps because o-ring seals are used. The nuts and caps are designed to be unscrewed or tightened
by hand or with the special plastic Service Wrench, #V3193. If necessary a pliers can be used to unscrew the nut or
cap. Do not use a pipe wrench to tighten nuts or caps.
Do not place screwdriver in slots on caps and/or tap with a hammer.
Water Pressure, 20-125 psi (138-862 kPa).
Water temperature, 40° -110° F (4° - 38° C)
The tanks should be on a firm level surface
Electrical: Use a 115/120V, 60Hz uninterrupted outlet.
1. The distance between the drain and the water conditioner should be as short as possible.
2. Since salt must be periodically added to the brine tank, it should be located where it is easily accessible.
3. Do not install any water conditioner with less than 10 feet (3m) of piping between its outlet and the inlet of a water
heater. Water heaters sometimes overheat to the extent that they will transmit heat or backflow from their inlet back
to the water conditioner control. Hot water can severely damage the conditioner. Allowing the 10 foot (3m) distance
will permit most heat to dissipate before reaching the water conditioner. A more positive way of insuring against
backflow is to install a high temperature check valve. The heater should also have a properly rated temperature and
pressure relief valve. Also, be certain that local codes are not violated.
4. Do not locate unit where it or its connections (including the drain and overflow lines) will ever be subjected to
room temperatures under 34° F (49° C).
5. The use of resin cleaners in an unvented enclosure is not recommended.
SERIAL NUMBER: Record the serial number on the installer‟s and customer‟s records.

INSTALLATION

GENERAL INSTALLATION & SERVICE WARNINGS
SITE REQUIREMENTS
●
Current draw is 0.5 amperes.
● A 15 ft power cord is furnished.
●
The plug-in transformer is for dry locations only.
● Batteries are not used.
13