Set Time Of Day; User Display Settings - Water Depot PLATINUM SERIES Owner's Manual

The user can also set the time of day. Time of day should only need to be set after extended power outages or when daylight
saving time begins or ends. If an extended power outage occurs, the time of day will flash on and off which indicates the time
of day should be reset.
General Operation
When the system is operating, one of five displays may be
shown. The displays normally rotate, however pressing NEXT
will pause on the selected display for 5 minutes. Pressing NEXT
will alternate between the displays. One of the displays is
always the current time of day. The second display is one of the
following: days remaining or volume remaining. Days remaining
is the number of days left before the system goes through a
regeneration cycle. Capacity remaining is the gallons that will
be treated before the system goes through a regeneration cycle.
Pressing the  button while in the Capacity Remaining display
will decrease the capacity remaining in 10 gallon increments and
will also increase the volume used impacting the recorded values
in Diagnostics Steps 3D, 4D and 5D and Valve History, Step 4VH.
The third display shows the current treated water flow rate
through the system. The fourth display will show either dP or
hold if the dP switch is closed. The fifth display indicates the
user should call for service. The fifth display will not appear if
OFF is selected in Step 13S of Softener System Setup or
Step 12F of Filter System Setup. To clear the Service Call
reminder, press the  and  buttons simultaneously while
CALL
is displayed.
If the system has called for a regeneration that will occur at the
preset time of regeneration, the words REGEN TODAY will
appear on the display.
If a water meter is installed, the word "Softening" or "Filtering"
flashes on the display when water is being treated (i.e. water is
flowing through the system)

SET TIME OF DAY

STEP 1U – Press CLOCK.
STEP 2U - Current Time (hour): Set the hour of the day using  or  buttons. AM/PM
toggles after 12.
Press NEXT to go to Step 3U.
STEP 3U - Current Time (minutes): Set the minutes of the day using  or  buttons. Press
NEXT to exit
Set Time of Day. Press REGEN to return to previous step.
STEP 2U
STEP 3U

USER DISPLAY SETTINGS

Page 4