Oil Pump And Chain Installation - Polaris RZR 170 2009 Service Manual

ENGINE
5. Install the Starter Drive one-way gear assembly, washer
and slotted nut.
6. Using Slotted Nut Socket PA-49935, tighten the crank shaft
nut to the specified torque. NOTE: Slotted nut is left hand
threaded.
Install
Crankshaft Slotted Nut Torque:
43 ft. lbs. (59 Nm)
Special Tool:
PA-49935
3.36
= T
7. Install the baffle plate and torque to specification.
Baffle Plate Screw Torque:
5-7 ft. lbs. (7-9 Nm)

Oil Pump and Chain Installation

NOTE: Oil pump is not a serviceable assembly. Do
not disassemble pump. Replace entire component.
1. Inspect the oil pump sealing surface on the crankcase.
Apply a liberal amount of engine oil to the surfaces and
pump.
NOTE: Do not use gasket sealer on the pump
mating surfaces.
2. Install oil pump as shown. Install and torque screws to
specification.
Install with the oil galley pointing down
Oil Pump Cover Screw Torque:
4-5 ft. lbs. (5-7 Nm)
= T
= T