Polaris RZR 170 2009 Service Manual page 134

BRAKES
10. At caliper end of parking brake cable, have an assistant
push inner cable into the outer cable casing as far as
possible to maximize slack at the lever end.
11. Remove cable from lever arm.
12. Pull cable out of holder on frame.
Cable Installation
1. On a new cable or if adjuster was loosened upon removal,
turn cable adjuster out until approximately 3/4
thread is exposed. Screw jam nut against the adjuster nut.
Hold adjuster and tighten jam nut securely.
2. Route cable to passenger side of shift cables, and through
holder on park brake lever bracket.
3. Pull inner cable and attach it to parking brake lever arm.
4. Refer to routing photos shown in the cable removal process
to route the cable along the frame rails and out the right side
near swingarm pivot.
5. Secure cable to frame with new tie straps.
6. Carefully remove supports and lower the vehicle.
7. Route cable through guide at front of swingarm and back
to rear caliper.
8. Secure cable to swingarm with rear brake line.
9. Connect caliper end of the cable.
10. Adjust parking brake. See "Parking Brake Adjustment" on
page 6.8.
6.10
1. Hold
2. Push

(20mm) of