Sensor Alarm - Q-See QSTC211 User Manual

QSTC201/211 IP-CAMERA USER MANUAL
Press the "Save" button to save the settings.
Note: Day schedule is better than Week schedule.
Fig 5-9 alarm configuration—motion schedule interface

5.4.4 Sensor alarm

1. Enter into "Alarm configuration"--"Sensor alarm", refer to Figure 5-10:
2. Select the sensor which needs to be setup on the "Sensor" pull down list, and
set the sensor type: NO or NC.
3. Select the "Enable alarm" check box, all functions under this interface will be
activated.
4. Select the "Alarm output" in the "trigger alarm out" text box, it will trigger alarm
if the device connected to alarm is triggered.
5. Select the matched channel in "Trigger PTZ" text box, select "To preset" or
"Start cruise", when sensor detection triggers alarm, the PTZ install stand of the
device will move to corresponding preset point or cruise line.
6. Select "Trigger snap", user should also select a matched channel; the alarm
will be triggered when there was an alarm.
7. Press the "Save" button to save the settings.
33