Network Image Configuration - Q-See QSTC211 User Manual

QSTC201/211 IP-CAMERA USER MANUAL

5.3.3 Network image configuration

1. Enter into "Channel configuration"-- "Network image configuration" refer to
Figure 5-6:
Fig 5-6 channel configuration—network image configuration interface
2. Select the channel which needs to be setup on the "Channel" pull down list.
3. Select the resolution of the single frame image on the "Resolution" pull down
list.
4. Select the data stream type on the "Bit rate type" pull down list.
5. Select the speed of video per second at the "Frame rate" pull down list.
6. Set the video quality at the "Video quality" pull down list.
7. Press the "Save" button to save the settings.
Note: this user manual is taking the single channel device as an example,
so user can choose one channel at the "Channel" pull down list only, and
the "Copy function" is unavailable for copying this setting to other
channels. But for device with 4 channels and Multi-channels, this function
is available.
Please refer to the following table for parameters and instructions of network
image configuration.
30