Advertisement
Quick Links
Download this manual
See also:
User Manual
Q-SEE IP CAMERA MODEL QSTC201/211 QUICK INSTALLATION GUIDE
1. Connection Diagram
a. Connect the Q-See IP camera to the same Router as your PC.
2. Setting up the Connection on a PC
a. Find the IP address of the PC: To do this:
Go to Start – Run (XP) and type CMD. In Vista, type CMD in Search. You will get the Command prompt
screen. Type in "IPCONFIG". Note the IP Address, Subnet Mask Address and Default Gateway Address
listed on your command screen and write these down for future reference. See example below (Figure
1).
b. Insert the installation CD for the Q-See IP camera and Install the Q-See IP Camera as prompted by the
pop-up menu that appears on your screen.
c. Once the Q-See IP Camera Software is installed:
Go to: Start-All Programs-ControlCenter-IPTOOL. You will see a dialog box listing all connected IP
Cameras with the appropriate Addresses listed. See example below (Figure 2).
*Note that the example of this IPTOOL screen above lists an IP Camera with the Device Name of "name",
*Note the IP Address for this example is 192.168.0.105,
the Subnet Mask is 255.255.255.0 and the Default Gateway is 192.168.0.1
an IP Address of 192.168.1.201, a Subnet Mask of 255.255.255.0 and a Gateway of 192.168.1.1
(Figure 1)
(Figure 2)
Advertisement
Related Manuals for Q-See QSTC201
Summary of Contents for Q-See QSTC201
- Page 1 *Note the IP Address for this example is 192.168.0.105, the Subnet Mask is 255.255.255.0 and the Default Gateway is 192.168.0.1 b. Insert the installation CD for the Q-See IP camera and Install the Q-See IP Camera as prompted by the pop-up menu that appears on your screen.
- Page 2 d. If the IP Address, Subnet Mask and Gateway Address listed in the IPTOOL dialog box is different than those listed in your Command Screen (See Figure 1), then the IPTOOL Addresses and Subnet Mask must be changed accordingly. To do this, right click on the name of the Device with the Addresses you want to change (in this example below, the Device Name is “name”) and choose “network setup”...
- Page 3 (Figure 6) 3. Setting up the Wireless Function of the Camera a. In your Internet Explorer Browser window (See Figure 7), click on the “System Config” button on the bottom right hand side of your screen. b. A Menu Box will appear (See Figure 7). In this Menu Box, choose the “Wireless config” option nested under “Network config”...
- Page 4 Router’s manual for more accurate and detailed information. g. Run the IPTOOL program again to ensure that your new Q-See IP Camera is detected by your Router. If not, station your camera closer to your Router.