Startup Terminal Messages - 3Com NETBUILDER II Installation Manual

C-2 A C: S
PPENDIX TARTUP
Startup Terminal
Messages
M
ESSAGES
Module
being tested
Slot number of module
Self test
ST:ENET: # : TTTT
FAIL XXXX
Failure description
Figure C-2 Self-Test Failure Message
Refer to Chapter A, Troubleshooting and Maintenance, to determine what action you
should take if the LCD displays a self-test failure message.
The NETBuilder II base system's power-on terminal messages include a check of the
Ethernet system. This section lists and describes only messages specific to the
Ethernet module.
Ethernet Controller - Self-Tests Initiated - Slot X
Meaning: This message appears when the Ethernet controller tests are initiated. The
value of X can be 1 through 8, depending on which NETBuilder II chassis
you have.
Ethernet Controller - Self-Tests Passed - Slot X
Meaning: This message appears if no errors are encountered in the Ethernet
controller tests. The value of X can be 1 through 8, depending on which
NETBuilder II chassis you have.
Ethernet Controller - Self-Tests Failed - Slot X
Meaning: This message appears if an error is encountered in the Ethernet controller
tests.
Action: When you see this message on the terminal screen, refer to the LCD. The
LCD message provides detailed information, which will help you
determine the specific self-test that failed and the nature of the failure.
The value of X can be 1 through 8, depending on which NETBuilder II
chassis you have.
Subtest being performed
on module