This Guide - 3Com NETBUILDER II Installation Manual

Introduction
Conventions
A T
BOUT HIS
This guide provides the information necessary to install, cable, maintain, and
troubleshoot the Ethernet I/O module for the NETBuilder II
NETBuilder II system is available with a 4- and 8-Slot chassis. Information applies to
both chassis whenever the generic NETBuilder II system name is used in a description.
References to the 4-Slot or 8-Slot chassis are specifically identified.
For more information on the NETBuilder II base system, refer to the NETBuilder II Base
System Installation Guide.
This guide is intended for the system administrator, network equipment installer, or
network manager who is responsible for installing and managing the network
hardware. It assumes a working knowledge of network operations, but does not
assume prior knowledge of 3Com
If the information in the release notes shipped with your product differs from the
information in this guide, follow the release notes.
Table 2 and Table 1 list conventions that are used throughout this guide.
Table 1 Notice Icons
Icon Type
Information Note Information notes call attention to important features or
Caution
Warning
G
UIDE
®
internetworking equipment.
Description
instructions.
Cautions alert you to personal safety risk, system damage,
or loss of data.
Warnings alert you to the risk of severe personal injury.
®
base system. The