Panasonic SF4B-H12C Instruction Manual page 52

Wiring
<In case of using I/O circuit for NPN output with SF4B-□CA-J05>
Gray cable
Gray cable
with black line
Interlock function
External device monitor function Valid
Auxiliary output
The device output is selected depending on the connecting state of the output polarity setting wire
(shield). Incorrect wiring may cause the lockout state.
* Symbols
Switch S1
0 to +1.5V (source current 5mA or less): Emission halt, Open: Emission
K1, K2: External device (Forced guided relay or magnetic contactor)
Note: For resetting, refer to "3-2 Interlock Function."
52
Ramco National
(Gray) NC
(Gray / Black) Large multi-purpose indicator input (Emitter side)
(Red) Muting auxiliary output
(Yellow) Override input
(Brown) +V
(Yellow-green / Black) Auxiliary output
(Shield) Output polarity setting wire
(Pink) Emission halt input / Reset input
(Pale purple) Interlock setting input
(Blue) 0V
(Orange) Synchronization +
(Orange / Black) Synchronization -
(Orange / Black) Synchronization -
(Orange) Synchronization +
(Yellow-green) External device monitor input
(Brown) +V
(Black) Control output 1 (OSSD 1)
(White) Control output 2 (OSSD 2)
(Shield) Output polarity setting wire
(Blue) 0V
(Sky-blue / White) Muting input A
(Sky-blue / Black) Muting input B
(Gray / Black) Large multi-purpose indicator input (Receiver side)
(Gray) NC
Valid (Manual reset)
Can be used
800-280-6933 | nsales@ramcoi.com
Load
K1
K1
K2
© Panasonic Industrial Devices SUNX Co., Ltd. 2014
www.panasonicsensors.com
+
24V DC
±10%
-
*S1
K2