Information Messages - Husqvarna AUTOMOWER 440 Operator's Manual

Message Cause
Charging current too Wrong or faulty power supply unit.
high
Connectivity problem Potential problem on the connectivity circuit
board in the mower.
Connectivity settings
The connectivity settings was restored due to
restored a fault.
Poor signal quality
The connectivity circuit board in the mower is
assembled upside down, or the mower itself
is tilted or upside down.

6.3 Information messages

Below a number of information messages are listed which may be shown in the display of the robotic lawnmower.
Contact your local Husqvarna representative if the same message appears often.
Message Cause
Low battery
The robotic lawnmower cannot find the charg-
ing station.
The guide wire is broken or not connected.
The battery is spent.
The charging station's antenna is defective.
Settings restored
Confirmation that a
has been carried out.
Limited cutting height
The maximum and minimum position of the
range
cutting height adjustment is limited.
Unexpected cutting
The cutting height adjustment is altered with-
height adj
out a request from the robotic lawnmower.
Cutting system imbal-
The robotic lawnmower has discovered vibra-
ance
tions in the cutting disc.
52 - Troubleshooting
Reset all user settings
Action
Restart the mower.
If the problem remains, the message requires
action by authorized service technician.
Restart the mower.
If the problem remains, the message requires
action by authorized service technician.
Please check and change the settings if nee-
ded.
Verify the mower is not upside down or tilted.
If not, the message requires action by author-
ized service technician.
Action
Check that the charging station and the guide
wire are installed in accordance with the in-
structions. See Installation on page 11 .
Find out where the break is and rectify it.
Replace the battery. See
Check if the indicator lamp in the charging
Indicator lamp in the
station flashes red. See
charging station on page 54 .
This is normal. No action required.
Check that there no grass or other objects
are blocking the blade disc from moving up or
down.
Carry out a cutting height calibration. Contact
your local Husqvarna representative.
Contact your local Husqvarna representative
if this message appears often.
Carry out a cutting height calibration. Contact
your local Husqvarna representative.
Contact your local Husqvarna representative
if this message appears often.
Verify that the blades (and screws) are intact
and not worn out. Verify that all blades are
correctly mounted. Check that no double
blades are mounted on any of the three blade
positions.
Battery on page 48 .
447 - 001 -